As I understand it for a ZUNO_SWITCH_BINARY. The getter is called when the controller polls the device.
is zunoSendReport basically asking the controller to poll the z-uno?
I'm asking because it seems to only take a channel number, not a value.
So if the "STATE" of the device changes externally to the z-uno, can I use zunoSendReport to update the status on the controller?
question about zunoSendReport
Re: question about zunoSendReport
The getter is called in two cases:
- when controller sends a Get to Z-Uno (solicited Report) and
when zunoSendReport is called (unsolicited Report)
Re: question about zunoSendReport
Oh, Thank you!
I must have missed that when reading the Guide.
I must have missed that when reading the Guide.