Opnehab 2 interoperability proposal
Posted: 22 Nov 2017 11:35
Hi,
I am currently working on supporting a sketch under Openhab2. It works fine when I define the device XML in OH2 correctly.The problem arises if I want to have a second Z-Uno with another sketch supported, because OH2 does not support yet dynamic endpoint detection and still requires a predefined device XML for accurate device detection.
After checking the reported node xml from OH2 corresponding to the Z-Uno device, I see that the Command Class Version is reported back as supported (I guess this is a must for each Z-Wave device). The application version being reported is in my case 2.11, that is the latest Z-Uno firmware version.
Is it possible to provide an API for Z-Uno to be able to set this application version from inside a sketch?
By doing so, we can set a different version for each sketch, and based on this version, we define a specific device xml in the openhab2 binding fitting to the endpoints of this sketch. This will provide a 100% interoperability for multiple Z-Uno devices in the same network under Openhab2.
Do you think it is possible to include such change in next update?
Thanks
I am currently working on supporting a sketch under Openhab2. It works fine when I define the device XML in OH2 correctly.The problem arises if I want to have a second Z-Uno with another sketch supported, because OH2 does not support yet dynamic endpoint detection and still requires a predefined device XML for accurate device detection.
After checking the reported node xml from OH2 corresponding to the Z-Uno device, I see that the Command Class Version is reported back as supported (I guess this is a must for each Z-Wave device). The application version being reported is in my case 2.11, that is the latest Z-Uno firmware version.
Is it possible to provide an API for Z-Uno to be able to set this application version from inside a sketch?
By doing so, we can set a different version for each sketch, and based on this version, we define a specific device xml in the openhab2 binding fitting to the endpoints of this sketch. This will provide a 100% interoperability for multiple Z-Uno devices in the same network under Openhab2.
Do you think it is possible to include such change in next update?
Thanks