Page 1 of 1

Z-UNO and Fibaro Wall Plug FGWPE no inclusion...

Posted: 02 Dec 2017 12:15
by jeanot1314
Hi,

I am new to program Z-UNO but confirmed in Arduino ^^
I just program my Z-uno with several exemples and I wanted to try the "Battery Power wall switch"
I bought a module from Fibaro call Wall Plug FGWPE and put it to inclusion mode.

On Z-uno everything compile and upload with the 1.6.5 IDE on my MAC, I just changed the Frequency to "Europe".
When I try to press three times the button, I can see a red LED blinking on the board, but nothing happen on the Wall Plug...
I tried with other exemple program and nothing as well..

The inclusion is fully independent from the Arduino sketch right? Is this could be from a "profile" problem?

Any ideas?

Thanks :)

Re: Z-UNO and Fibaro Wall Plug FGWPE no inclusion...

Posted: 07 Jan 2018 03:01
by PoltoS
Z-Uno and Fibaro Wall Plug are both slave devices. They have to be included in a Z-Wave controller (like RaZberry). Then you an bind them via associations.