forum

Hello,

Testing the Z-Uno on the Wink Hub 2. I programmed the Z-Uno using the "ControlRelay" example and then put my Wink Hub 2 in Inclusion Mode and then pressed BTN 3x. But nothing happens. I also tried adding a generic light on the Wink Hub but no success.

Any recommendations on what I can try to get it to work?

Disregard. Works on Wink Hub 2. Didnt have the Frequency set properly.

I am trying to pair my Z-Uno with my Wink 2 hub. Could you please reach out to me to let me know how you achieved this. I have been trying for days.

Thank you

Steve
chipconnect1@gmail.com

Any update on this? I have also been trying for days to pair. I am using the binary switch example and my wink 2 hub will not recognize the Z-Uno.

I have the frequency set to USA when I upload the sketch. I have tried using inclusion mode and the "Add Product" with "Generic A-Wave Binary Switch".

Is there any way to check what the frequency of my hub is set to? I am only assuming its USA because that's where I live. It works with all of my other z-wave devices.

Try to disable Security, set USA, disable MultiCommand.

We have never tried Wink, but with simple sketch it should work out of the box.

Try to exclude first