Hello everybody
I just took my first steps with the z-uno and ran into the following compiler error.
Windows 10
Arduino IDE: 1.6.6
steps taken so far:
1. burned bootloader 2.1.4 SUCCESS
2. included z-uno into z-wave mesh, and tested pre-installed dimmer/blink program SUCCESS
3. excluded z-uno SUCCESS
Now when trying to compile blink or any other example the third line on the output window reads:
"C:\Users\[...]\00.08.70/zuno_toolchain/compiler" arduino_preproc1 "C:\Users\[...]\sketch\Blink.ino.cpp" -r "C:\Users\[...]\zw8051\2.1.4"
And the compiler responds with
usage: compiler [-h]
{dummy,size,build,prog,boot,erase,readnvm,arduino_preproc} ...
The part of the paths I have replace with [...] contains no spaces.
Any ideas what's causing the erroneous "arduino_preproc1" flag?
Thanks
Sebastian
Bugreport Compiler - getting started
Re: Bugreport Compiler - getting started
Hello again
I have resolved the issue by installing version 1.8.5 of the IDE.
Thanks
I have resolved the issue by installing version 1.8.5 of the IDE.
Thanks