With the current two Z-Uno v2's I'm using, inclusion fails if I try to use more than one binary sensor. The inclusion starts, and the hub starts to interview the device, but the interview times out, and the device just shows up as supporting 'ping'. If it limit the capabilities to just a single sensor and single button, then inclusion correctly identifies the two channels. If I try just adding one more sensor, inclusion will just timeout, again.
Meanwhile, the sketch uploads and runs fine; it's the z-wave inclusion which fails to describe to the hub what the capabilities are. This is all with Home Assistant, by the way.
Examples:
This works:
Code: Select all
ZUNO_SETUP_CHANNELS(
ZUNO_SENSOR_BINARY(ZUNO_SENSOR_BINARY_TYPE_HEAT, getter0),
// ZUNO_SENSOR_BINARY(ZUNO_SENSOR_BINARY_TYPE_WATER, getter1),
// ZUNO_SENSOR_BINARY(ZUNO_SENSOR_BINARY_TYPE_FREEZE, getter2),
// ZUNO_SENSOR_BINARY(ZUNO_SENSOR_BINARY_TYPE_TAMPER, getter3),
ZUNO_SWITCH_BINARY(pseduo_switch_getter, pseduo_switch_setter)
);
Code: Select all
ZUNO_SETUP_CHANNELS(
ZUNO_SENSOR_BINARY(ZUNO_SENSOR_BINARY_TYPE_HEAT, getter0),
ZUNO_SENSOR_BINARY(ZUNO_SENSOR_BINARY_TYPE_WATER, getter1),
// ZUNO_SENSOR_BINARY(ZUNO_SENSOR_BINARY_TYPE_FREEZE, getter2),
// ZUNO_SENSOR_BINARY(ZUNO_SENSOR_BINARY_TYPE_TAMPER, getter3),
ZUNO_SWITCH_BINARY(pseduo_switch_getter, pseduo_switch_setter)
);